LocationNewsCatalogContact UsCalmini

 

CALMINI Project V6 Vitara Extreme

CALMINI Project 2000 Suzuki Vitara- as seen at www.zukiworld.com .Special 2.5L V6 installation, Auto, A/C, Power windows, CD, removable factory hard top, CALMINI 5.83:1 axle ratios, CALMINI 4.24:1 Transfer Case reduction, Limited Slip Diffs front & rear, 2.5" CALMINI Suspension Lift, Custom 3" Body Lift, Custom CALMINI front and rear bumpers, Warn winch, side Rocker Skids, full tranny, t-case, gas tank, and axle skid plates. This vehicle was custom built by CALMINI for American Suzuki Motor Corp. as a media promotions vehicle, it has less than 8K miles on it. Fully smogged, uses all factory parts - not a hack job. You can't tell it from factory showroom. It's in pristine condition inside and out (not 1 dent) and really one of a kind. An absolutely perfect vehicle for exploring or towing behind an RV, but with real hardcore off-road capability. Available with or without full body graphics. Serious inquires only.
Price $18,500.00  SOLD
Contact CALMINI Products: 800-345-3305

 

CALMINI Project Samurai Nickname "Cobby"

1988.5 Samurai.  Extras include:  1.6L Sidekick engine conversion.   CALMINI 5.43 ratio axles & Detroit E-Z Lockers front & rear  CALMINI ROCKCRAWLER 4.16:1 Transfer Case Kit (total low range of 82:1)   CALMINI Tri-Y Header and complete 2" Hi-Flow Exhaust  Centerforce Clutch, CALMNI Super 5" Shackle Reverse Lift Combo,  CALMINI Axle Truss/Skid Plates F&R,  CALMINI Transfer Case Skid Plate  CALMINI Linkage Steering Kit   CALMINI Power Steering Conversion  CALMINI C2 Front Winch Bumper w/ Warn M5000 Winch. (used once)  CALMINI C2 Rear swing away Bumper  CALMINI Tubular Safari Rack w/PIAA Series 50 Lights. (never used)   CALMINI Fender Flare Kit   CALMINI Rocker guards & Trim Kit  CALMINI Rocker Skids  5 Goodyear 31x 11.50 MT tires mounted on 15 x 8.5" Centerline Hellcat Wheels. Maybe 2000 mi on them  CALMINI 6 point Interior Cage w/ custom seat mounting integrated into cage, Complete sprayed Durabak Interior,  PRP Custom Race Seats w/ 4 point harnesses.  Premier Power welder on board. (used fixing everyone else's rigs)  Quick Air on board air compressor, Dual Optima Batteries in CALMINI Mounting system  Kayline removable soft doors, CB Radio,  Like new paint and a dent free body. They don't get nicer. Serious inquires only. It needs a new home. It's dying to get used.

Price $10,500    SOLD

 

CALMINI/Vintage Suzuki Project Nickname- "Spyderman"

 1998 CALMINI Project Suzuki Sidekick- Four Door Wagon with just over 8,000 miles on finished rig. Please see the full build up from start to first trail run, on http://www.zukiworld.com/ or http://www.vintagesuzuki.com/. 30,500 original miles, automatic transmission, power-steering, air-conditioning, AM/FM/ Cassette with factory 6 Disc Changer. CALMINI thermal coated exhaust header with 2" exhaust system (factory catalytic converter), CALMINI'S 3 inch suspension kit complemented by their 3 inch body lift kit. Project built up includes 5:12 ring and pinion gear sets, limited slip in the rear, limited slip in the front diff driven by CALMINI'S new 4.239:1 transfer-case low-range gear set with no effect on the high range gearing. Mickey Thompson 15 X 8 mag wheels  15/235/15 BF Goodrich All Terrain T/A KO’s. Full undercarriage armor includes rear axle truss support, transfer-case guard, transmission guard, engine guard which is tied into the new Calmini front winch bumper. New 8000# Warn winch, used three times (to pull a couple of Samurai's out). And finally, the best part of the whole project, the CALMINI Rock Sliders that have protected the doors and sills over the most brutal of terrain.

$9,995.00      SOLD

 

Calmini Products, Inc.
6951 McDivitt Drive
Bakersfield, CA 93313   USA

Home | About Us | Location | News | Contact Us | a division of Calmini

This site created and maintained by CALMINI Products Inc. Copyright © CALMINI Products Inc. 1997,1998,1999, 2000, 2001,2002,2003,2004,2005
DO NOT REPRODUCE FOR COMMERCIAL PURPOSES WITHOUT WRITTEN APPROVAL FROM CALMINI Products Inc.


Website designed & maintained by: DesignMechanix 2006